Volcano box make scatter file?
![volcano box make scatter file? volcano box make scatter file?](http://2.bp.blogspot.com/-taWCcDpQuPQ/VAApXxqXlAI/AAAAAAAAD9s/wZbDb3BY5zA/s1600/2014-08-29_111804.jpg)
You should now see the FOUND RKANDROID LOADER ROCK USB at the bottom of the program screen, this is good your device is connected. Go into the firmware folder and start the RK29 update program. Installing firmware using the Rockchip RKAndroid Tool That is the driver installed and ready to go! You can now see the RK29 Device in device manager.
#Volcano box make scatter file? install
See belowĬlick the always trust software from box, and this will install the Rockchip drivers on your computer and you will see this come up when finished. This will now load the Rockchip driver for your tablet. Locate the firmware folder and go to the drivers folder and select the correct driver for your operating system. Now click browse my computer for driver software. Now go into device manager on your computer and look for the UNKNOWN DEVICE, right click and select update device software and you will be presented with this screen. You will now see this pop up on your computer. This is the Arnova 10G2 Method, please refer to your own tablet recovery mode.Ģ) Press the reset button for two seconds than release while still holding the volume buttom, a few seconds later the tablet will go into recovery mode, the screen goes black.ģ) Connect your tablet to your Pc with the supplied cable. Please follow the instruction below to install the Rockchip drivers onto your computer for purposes of flashing your tablet with custom firmware etc.
![volcano box make scatter file? volcano box make scatter file?](https://1.bp.blogspot.com/-ALQUWX2pI0Y/Xm4FhfyCKNI/AAAAAAAAET4/udEBP2dPINw1Roi1LYOFisAkKP60JPCqwCNcBGAsYHQ/w1200-h630-p-k-no-nu/ice_screenshot_20180114-222953ff.png)
Installing drivers for Rockchip based Tablets! Installing Rockchip drivers for flashing!